ATEN ACS-1208AL - Manual (Page 39)

(F3 SET: continued)
Setting Function
PORT ID
DISPLAY
MODE Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or
the Port Number plus the Port Name (PORT NUMBER +
PORT NAME). The default is PORT NUMBER + PORT
NAME).
SCAN
DURATION Determines how long the focus dwells on each port as it
cycles through the selected ports in Auto Scan Mode (see F7
SCAN, p. 4-14). Key in a value from 1 - 255 seconds, then
press [Enter]. Default is 5 seconds; a setting of 0 disables the
Scan function.
SCAN/SKIP
MODE Selects which computers will be accessed under Skip Mode
(see F5 SKP, p. 4-12), and Auto Scan Mode (see F7 SCAN,
p. 4-14). Choices are:
ALL - All the Ports which have been set Accessible (see SET
ACCESSIBLE PORTS, p. 4-10);
QUICK VIEW - Only those Ports which have been set
Accessible and have been selected as Quick View Ports (see
SET QUICK VIEW PORTS, p. 4-10);
POWERED ON - Only those Ports which have been set
Accessible and are Powered On;
QUICK VIEW + POWERED ON - Only those Ports which
have been set Accessible and have been selected as Quick
View Ports and are Powered On. The default is ALL.
SCREEN
BLANKER If there is no input from the console for the amount of time set
with this function, the screen is blanked. Key in a value from
1 - 30 minutes, then press [Enter]. A setting of 0 disables this
function. The default is 0 (disabled).
HOTKEY
COMMAND
MODE Enables / Disables the Hotkey Command function in case a
conflict with programs running on the computers occurs.
2003-01-27
OSD Operation
4-7