AmbiCom WL1100B-AR - Manual (Page 9)

-5-
2-3 Mechanical Description
Top panel of the WL1100B-AR Wireless LAN Access Router:
The following table provides an overview of each LED activity:
LED Definition Activity Description
PWR Continuous Green Power enabled
AP Continuous Green
The WL1100B-AR Wireless LAN
Access Router is ready in service.
Off: No wireless activity
WLAN Flashing Green
Flashing: Wireless RX/TX activity
Off: No Ethernet traffic activity
LAN Flashing Green
Flashing: Wired LAN traffic activity
Off: no station connected to the
WL1100B-AR Wireless LAN Access
Router
LINK Continuous Green
On: with one or more stations
associated to the WL1100B-AR
Wireless LAN Access Router
Back panel of the WL1100B-AR Wireless LAN Access Router:
Power Socket
The power adapter plugs into the socket labeled “POWER”.
Ethernet Ports
The WL1100B-AR Wireless LAN Access Router supports an Ethernet ports: RJ-45 MDI
daisy-chain port (labeled “MDI”). You may connect the WL1100B-AR Wireless LAN
Access Router either to a hub or a PC. Please note that, use the cross-over cable when you
desire to connect the Access Point to a PC. The two LEDs (10/100/Link) next to the
Ethernet ports indicate the Ethernet physical link status. The ‘Link’ LED is a good indicator
for to see if you have proper Ethernet connection.
Default
The button labeled “DEFAULT” enables you to restore the WL1100B-AR Wireless LAN
Access Router’s default setting. This is used when you forget the password. Press the
“DEFAULT” button on the back panel of the 11Mbps WL1100B-AR Wireless LAN Access
Router. Hold the button in for a few second until the AP