Brother NC-2010p - Manual (Page 84)

USER’S GUIDE
8-6
PATHWORKS for Macintosh Configuration
If you are using PATHWORKS for Macintosh, you will need to make sure
that you have a bi-directional channel (in other words, you did NOT enter
the command
SET SERVICE servicename RECEIVE ENABLED
from the remote console). Then create a LAT port using LATCP as shown
in the following example (substitute your actual node name and LAT port
number):
CREATE PORT LTA53:/APPLICATION
SET PORT LTA53:/NODE=BRO_009C53/PORT=P1
Do not set the LAT port as a spooled device. Now go into ADMIN/MSA
and enter the command:
ADD PRINTER name/QUEUE=queuename/DEST=LTA53:
where name is the name of the printer, and queuename is the queue
name.
DECprint Supervisor Configuration Notes
If you want to use the Brother print server with the DECprint Supervisor
software, you must have the DCPS-Open option in order to support Brother
printers (you may also need to modify the DCPS device control modules
and queue setup to handle "unrecognized" printers). Do not use the
SET
SERVICE RECEIVE command because bi-directional communications is
required for DCPS.