ADIC DAS V3.10E - Manual (Page 12)

12 Release Notes
603108 Rev A
It is possible to configure in the DAS configuration
file a relation between drives and volsers in the
following syntax:
For each drive that needs an attachment, a
DriveToVol statement must be configured as above.
This means that only the specified volsers can be
mounted into drive Drive1
When no relation for a drive in the configuration
file exists, each volume of the correct type can be
mounted into the drive.
The statement is optional.
Step 5 If using DUALDAS, ensure that the port 5000 is not
being used by another application. If the port is in
use, change the port in the Server statement of the
DAS config file.
ACI Installation
Perform the following steps to install ACI on the UNIX
platforms.
Step 1 Copy the ACI tar file in the directory c:\das of
the AMU PC
Step 2 Step 2 Copy the tar file to the client host using FTP.
Step 3 Step 3 Unpack the tar file using telnet or directly at
the UNIX host
DriveToVol drive = DriveName,
volsers =( (Volserrange1)|(Volser),
(Volserrange2)|(Volser)) ,...)