Basic frame assembly, 2 end ribs, Middle ribs – ShelterLogic 27273 24 x 40 UltraMax Peak Canopy User Manual

Page 3: Step 1 step 2 step 3 step 4

PAGE 3

Basic Frame Assembly

STEP 1

STEP 2

STEP 3

STEP 4

Assemble the wind brace set as shown in the

illustrations.

Step 2A

Fit together the end rib using the following parts

(1) #800091 3-Way Top Connectors

(2) #800096 Rafter Poles

(2) #800095 Common Tubes

(2) #800092 3-Way Side Connectors

(1) Wind Brace set

Step 2B

Fit together the middle rib using the following parts

(1) #800093 4-Way Top Connectors

(2) #800096 Rafter Poles

(2) #800095 Common Tubes

(2) #800094 4-Way Side Connectors

(1) Wind Brace set

Using (6) #800218 (5/16" x3" Bolts) and (6) Nuts securely

fasten these tubes. Lay these ribs on the ground at the rear

of your shelters designated location.

Fig. 4B

Fig. 4A

NOTE: Be sure that all of the heads of the bolts are

facing toward the outside of the rib.

Repeat step 2A/2B for all the other ribs.

Using #800098 Cross Rails, #800217

(5/16" x 2" Bolts) and Nuts to connect

these ribs.

800098

800216

800095

Assemble (2) #800216 Corner Support Tubes and (4) # 800095 middle support tube as shown in Fig. 4A and set aside.

Assemble other side Support Tubes as shown in Fig. 4B and connect the middle support tubes with #800218 (5/16" x 3"

Bolts) and nuts. Repeat this step at opposite side.

Note: #800218 Bolts are required for middle support tube connections. Bolts are not inserted to the corner legs

(#800216) at this step.

#800217

#00690

#800103

#800104

Fig. 2A

Fig. 1

Fig. 2B

2 End Ribs

800095

800092

Wind brace

800096

800091

Middle Ribs

800095

800094

Wind brace

800096

800093

#800218(5/16"x3"Bolt)