Audiovox AX-900 - Manual (Page 18)

128-6995
18 of 20
If you require more frequent starting please refer to auto start up timer mode
shown earlier in this guide.
NOTE: To insure accurate 24 Hour Start up, it is advisable to reset the start time
periodically as time may drift slightly each day.
Page Call Out:
From within the vehicle, if the valet push button is pressed for three seconds,
the alarm unit in the vehicle will transmit to the LCD remote and a beep tone
will be heard on the hand held transmitter indicating that someone is calling
you to the vehicle.
Timing Count Down:
The unit offers an additional count down timer for situations where an alert tone
may be needed to remind you of something important. For instance you may
have a meeting 4 hours from now and you want a reminder in 3 Hrs and 45
Mins. This additional count down timer allows you to set the count down up 19
Hours and 59 Minutes from the current time and when the timer reaches zero,
the transmitter will emit a tone or vibrate dependent on your preferred setting.
See chart for setting the count down time for this feature.
Valet:
When the System is in the valet mode, the icon shown will show in the
display when the status check buttons are activated.
Parking Meter Counter:
The transmitter has a built in clock that can count down from 10, 20, 30, 60, 90,
or 120 minutes. This feature is useful when parking the vehicle in a metered
parking lot. If the time on the parking meter is 30 minutes, you can set the
count down timer to 20 minutes. The transmitter will emit a beep tone when
the timer expires to remind you to get back to your vehicle. See following chart
for setting the parking meter count down timer feature.
Alarm Clock Mode:
The transmitter has a built in alarm clock that can be set to beep at a certain
time each day. The alarm clock mode must be set, and the feature turned on.
To use this feature please refer to the chart on the following page.
NOTE: Your system is shipped with two transmitters, 1 two way, shown on a
previous page, and the one way transmitter, shown below. The two way unit is
programmed from the factory with separate lock & unlock buttons, the key icon
button operates remote start and remote trunk release where applicable. The
option button and any button combination may be programmed to operate
various options. The one way transmitter is programmed as per the icons
shown on the button pad. Consult your installation center for button program-
ming and options that may have been added to your vehicle. Al-
though this is the default programming from the factory, this can be
changed for you to any configuration you prefer. Please refer to the
transmitter program guides included with your kit.
NOTE: While in the two way transmitter set up mode, 15 seconds of
inactivity, or pressing the "F" button for 5 seconds, will cause the set
up mode to be exited.
NOTE: A maximum of two of either style transmitter may be programmed to
your unit.