Activeforever CL 100-C - Manual (Page 24)

User’s Guide
24
Cleaning the Filter
1.
Unplug the power pack from the electrical outlet.
2. Using the three caps provided, cap the
suction and discharge fittings on the
inside of the spa.
3. Open the air bleed fitting on the top
of the filter tank.
4. Unscrew the retainer ring from the
filter housing and remove the filter
housing cover.
5. Lift the filter out of the filter housing.
Clean the filter with the spray from a
high pressure garden hose.
6. Place the filter back in the filter
housing. Make sure the filter is
properly seated in the housing and
that the o-ring is properly seated in
the o-ring groove.
7. Install the filter housing cover and
secure with the retaining ring. Tighten
the retaining ring hand-tight. Do not
over tighten the retaining ring.
8. Remove the caps from the spa suction
and discharge fittings inside the spa.
9. Open the air bleed fitting on the top of the filter housing. Leave the
bleed fitting open for one minute, or until water drips from the bleed
fitting. Close the bleed fitting.
10. Plug the power pack into the electrical outlet.
11. Reset the desired temperature set point.
Retaining
Ring
O-Ring
Groove
O-Ring