IEI Integration AFL-xxA-N270-Series v2.11 - Manual (Page 90)

AFL-xxA-N270 Series Panel PC
Page 76
rate of 44MBps (To use this mode, it is required that an
80-conductor ATA cable is used.)
UDMA4 Ultra DMA mode 4 selected with a maximum data transfer
rate of 66.6MBps (To use this mode, it is required that an
80-conductor ATA cable is used.)
UDMA5 Ultra DMA mode 5 selected with a maximum data transfer
rate of 99.9MBps (To use this mode, it is required that an
80-conductor ATA cable is used.)
S.M.A.R.T [Auto]
Use the S.M.A.R.T option to auto-detect, disable or enable Self-Monitoring Analysis and
Reporting Technology (SMART) on the drive on the specified channel. S.M.A.R.T predicts
impending drive failures. The S.M.A.R.T BIOS option enables or disables this function.
Auto D EFAULT
BIOS auto detects HDD SMART support.
Disabled Prevents BIOS from using the HDD SMART feature.
Enabled Allows BIOS to use the HDD SMART feature
32Bit Data Transfer [Enabled]
Use the 32Bit Data Transfer BIOS option to enables or disable 32-bit data transfers.
Disabled
Prevents the BIOS from using 32-bit data transfers.
Enabled D EFAULT
Allows BIOS to use 32-bit data transfers on supported
hard disk drives.
6.3.3 Super IO Configuration
Use the Super IO Configuration menu (
6
BIOS Menu 6 ) to set or change the
configurations for the FDD controllers, parallel ports and serial ports.