Figure 2-3: hdd retention screws, Figure 2–4: hdd installation – IEI Integration AFL-W19A_W19B_17D_W15A-GM45 v1.06 User Manual

Page 28

AFL-W19A/W19B/17D/W15A-GM45 Panel PC

Page 16

Step 5:

Attach the HDD brackets to the HDD. The brackets are different for each side.

Make sure the side with the hard drive screw hole further from the end goes at

the SATA connector end as shown in Figure 2-3.

Figure 2-3: HDD Retention Screws

Step 6:

Install the hard drive in the same position it was before.

Step 7:

Slide down from the top to connect the motherboard SATA connector to the hard

drive SATA connector.

Figure 2–4: HDD Installation

Step 8:

Fasten the screws.