Compliances, Fcc class b certification, Csa statement (canada) – Accton Technology CHEETAH PCI ADAPTER EN1207D-TX User Manual
Page 10
8
Quick Installation Guide
Compliances
FCC Class B Certification
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning! This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from the one which the receiver is connected to.
•
Consult the dealer or an experienced radio/TV technician
for help.
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void
your authority to operate the equipment.
Attach shielded or unshielded Category 3, 4 or 5 twisted-pair
cable to the RJ-45 port.
Note: In order to maintain compliance with the limits of a Class B digital device,
Accton requires that you use a quality interface cable when connecting to this
device. Changes or modifications not expressly approved by Accton could void the
user's authority to operate this equipment. Suggested cable type is 100
W
shielded
or unshielded Category 3, 4, or 5 twisted-pair cable for the RJ-45 port.
CSA Statement (Canada)
This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus set out in the
Radio Interference Regulations of Industry Canada.
Le présent appareil numérique n’émet pas de bruits radio-
électriques dépassant les limites applicables aux appareils
numériques de la classe B prescrites dens le Règlement sur
le brouillage radioélectrique édicté par l’Industrie.