Kasco Marine Quick Disconnect/Cord Connection - Manual

If your Kasco Fountain, Aerator, or Circulator has a 12 gauge power cord or larger, the cord has been
shipped separate from the unit. The unit itself has a 30”+ stub cord with the male half of the Quick
Disconnect. The cord that was shipped in a separate box has the female half of the Quick Disconnect.
To assemble the cord, the Quick Disconnect must be connected. Line up the pin assembly (male end)
from the stub cord to the socket assembly (female end) on the cord and push together.
Blue Nut
or collar
Once the two ends are together, tighten the large blue nut or collar to seal the connection. The blue nut
or collar should be HAND TIGHTENED ONLY!
Small Gap
after tightening
For seasonal removal, your Quick Disconnect includes an optional water tight cover. Simply separate
the Quick Disconnect halves and insert the sealing cover into the large blue nut or collar and tighten
fi rmly. The unit with the 30”+ stub cord can then be stored in a cool, dry place.
Quick Disconnect/Cord Connection
Instructions
Important - Read Carefully Before Installation
Kasco Marine, Inc.
800 Deere Rd.
Prescott, WI 54021
PH (715) 262-4488
FAX (715) 262-4487
www.kascomarine.com
#824360 Rev. 9/30/08