General Pump HTCK3623S - Manual (Page 8)

GENERAL PUMP
A member of the Interpump Group
HTCK3623S
2.1.3 REDUCTION CLASSES
Page 8
- Mount the rear cover complete with the O-ring, positioning the dipstick hole upward.
- Insert oil in the casing as indicated on the specification sheet.
Ref 300935 Rev.A
09-13
2.1.4 DISASSEMBLY/REASSEMBLY OF BEARINGS AND SHIMS
The type of bearings (taper roller) ensures the absence of axial clearance on the crankshaft. The shims are
defined to meet this necessity. For disassembly/reassembly and for any replacements, carefully observe
the following directions:
TABLE OF REDUCTIONS FOR CRANKSHAFTS AND CON-ROD HALF-BEARINGS
Recovery Classes
(mm)
P/N
Half-bearing
Upper
P/N
Half-bearing
Lower
Correction on the shaft
pin diameter
(mm)
0.25 90922100 90922400 Ø39.75 0/-0.02 Ra 0.4 Rt 3.5
0.50 90922200 90922600 Ø39.50 0/-0.02 Ra 0.4 Rt 3.5