Poweramp POWERHOLD SC 4.2003 - Manual (Page 6)

INSTALLATION CONTINUED
ELECTRICAL
Refer to the drawings indicated in Table I for the electrical installation. The drawings are
attached to this manual.
IMPORTANT
Make sure that the power supply requirement(s) as shown on the electrical
drawings and on the decal of the control assembly(s) are the correct
requirement(s) for the application.
TABLE I
DRAWING DESCRIPTION INFORMATION ON DRAWING
FIELD WIRING
DRAWING - ELECTRICAL DATA
- RECOMMENDED WIRE SIZES
- REQUIRED CONDUIT RUNS
- REQUIRED FIELD WIRES PER CONDUIT RUN
INTERCONNECTION
DRAWING - REQUIRED CONDUIT RUNS
- REQUIRED FIELD WIRES PER CONDUIT RUN
- TERMINATION POINTS FOR ALL FIELD WIRES
HYDRAULIC
Standard units are factory pre-connected so that no hydraulic field connections are
required. Standard units are shipped with a full reservoir of hydraulic fluid. In the event
of a fluid loss during shipment or installation, information concerning fluid
replenishment can be found in the maintenance instructions section of this manual.
2