AEG FAVORIT 403 - Manual (Page 28)

28
Installing
Positioning
Set the machine up as close as possible to a water tap and a connection for
waste water.
In order to ensure the door closes and seals properly, it is necessary for the
machine to stand firmly and horizontally on the floor.
Adjust the screw feet upwards and downwards until the machine stands
level.
Levelling
Good levelling is essential for correct closure and sealing of the door.
When the appliance is correctly levelled, the door will not catch on the
levelling spacers, either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet
until the machine is perfectly level.
Adapting the work-top
You can move the work-top 25 mm towards the front or the back so that it
fits exactly up against the kitchen cabinet. To do this, loosen the two fixing
screws at the rear, bring the work-top into the required position, and tighten
the screws again.
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it under a close fitting
sink unit or pre-existing top, providing the dimensions of the recess
correspond to those in the picture.
IN26
820
570 ÷
600
600
IN05