Atlona AT-HD88M-SR - Manual (Page 13)

11
+$5':$5( ,167$//$7,21
3(5)250$1&( *8,'(
AT-HD88M-S as master unit
1. Connect all sources to HDMI Inputs on the 8x8 HDMI over CAT5 matrix master AT-HD88M-S
2. Connect each CHANNEL CONTROL output port on the AT-HD88M-S to respective CHANNEL
CONTROL port on the remote receiver AT-HD88M-R
3. Connect each A/V SIGNAL output port on the AT-HD88M-S to respective A/V SIGNAL input on the
remote receiver AT-HD88M-R
4. Connect IR blaster to the IR MAIN jack of AT-HD88M-S and direct the IR blaster to the built-in IR
receiver of the sources
5. Connect the UL AC C13 power cord to the AT-HD88M-S
6. Power on all HDMI sources
7. Power on the AT-HD88M-S
AT-HD88M-R as receiver unit
1. Connect each HDMI output to HDMI displays
2. Connect the A/V SIGNAL port on the AT-HD88M-R to the A/V SIGNAL port on the AT-HD88M-S
3. Connect the CHANNEL CONTROL port on the AT-HD88M-R to the CHANNEL CONTROL port on the
AT-HD88M-S
4. Connect IR receiver and place the IR receiver at the appropriate position that can receive the IR
command signals sent from the users
5. Dial the 8-level rotary control switch to adjust the HDMI signal level until the picture and sound are
clear
Performance rating Type of LAN cable
Wiring Shielding CAT5 CAT5e CAT6
Solid
Unshielded (UTP)
  
Shielded (STP)
  
Stranded
Unshielded (UTP)
  
Shielded (STP)
  
Termination Please use EIA/TIA-568-B termination (T568B) at any time