MAX GS865E - Manual (Page 21)

21
Pusher Holder
w Pull the Pusher Holder as far as the rear and of the magazine and release it gently.
● Never put your face above the tool. Recoil of the tool may cause an
unexpected injury.
● Never bring your hand or finger close to the discharge outlet.
WARNING:
2
1
q Press Contact Arm against the object.
w Pull the Trigger.
HOW TO DRIVE THE PINS
Procedure
q Set the Battery and Fuel Cell in place.
w Press Contact Arm against where you want to drive the pins.
The fan motor is activated, the fuel gas is jetted, mixing the fuel with the air.
e Firmly pressing the Contact Arm, pull the Trigger. The pinls are driven into the object
by combustion of the fuel.
● Prior to starting work, be sure to check whether the tool functions as
mentioned above.
● If the tool is used for a long time, it could be heated and burn you.
If any abnormality is found, contact your nearest MAX authorized distributor
for inspection and repairing.
※ The fan keeps running for approx. 10 seconds even after driving the pins.
WARNING:
r The pins are not fired again even if the Contact Arm is applied to the object with the
Trigger pulled. Release the Trigger and repeat Step w.
REMOVING THE PIN
q Put your finger on the Pusher, pull it slightly to the rear, and then, let it back gently.
w Set the Magazine vertical and push the Pin Stopper to remove the Pin.
Pin
Pin Stopper
Pusher