IQinVision Alliance-mx Gang Box Adapter - Manual (Page 2)

3 Installation
1. Route the Ethernet cable through the opening in the Electrical Gang Box Adapter, and attach the adapter as
shown in Figure 2 using the four supplied #6 x 1”machine screws.
2. Route the Ethernet cable through the gasket installed in the enclosure. Attach the Alliance-mx series camera to
the adapter as shown Figure 3 using the four M4 x 12mm machine screws and sealing washers supplied with the
Alliance-mx dome camera.
3. After the field-of-view and focus are completed, attach the dome trim ring cover with shroud to the enclosure by
tightening the three tamper-proof screws with the Torx T-20 security wrench supplied with the Alliance-mx camera.
901-0265 Rev A
FIGURE 2
FIGURE 3
FIGURE 4