IQinVision Alliance Series Pendant Mount - Manual (Page 4)

4
c. Feed the cables into the Adapter Box through the rubber Heyco hole plug on the
rear of the box.
C. Attaching the Adapter Box to the Pendant Mount:
a. Reattach the Adapter Box to the Pendant Mount using the same (4) screws
removed during disassembly.
b. Go to the “Connecting the Camera and Finalizing Installation” section of this
installation guide.
Alliance-mx Pendant Mount Installation
A. The Alliance Pendant Mount is designed for installation indoors or outdoors.
B. Mounting the Pendant Mount to a masonry or other durable ceiling surface:
a.
Follow common mounting practices required to safely mount the Alliance
Pendant Mount to the intended surface.
b.
Pull any cabling from the ceiling side through the Pendant Mount and mount the
Pendant Mount to the ceiling surface using the supplied or equivalent hardw are.
c. Go to the “Connecting the Camera and Finalizing Installation” section of this
installation guide.
5 Connecting the Camera and Finalizing Installation
Alliance-pro
A. Make any cabling connections between the ceiling side and the Alliance-pro
camera.
B. Snap the Alliance-pro camera module into the Alliance Adapter Box by lining up any
one of the three (3) mounting tabs into the retaining channel and then snapping
the remaining two tabs in. Be sure to properly service loop the cabling for proper
fit and retained cable connectivity.
C. If desired, attach the supplied tether to the Dome Bubble / Trim Ring assembly.
D. After adjusting camera position, field of view and focus, attach the Dome Bubble/ Trim
Ring assembly to the Adapter Box by tightening the four (4) Torx screws that are
captively held in the Dome Bubble / Trim Ring assembly (Figure 5.1). Refer to
the Alliance-pro Installation and Operating Instructions for
additional details.
Figure 5.1