IQinVision Alliance-pro Series - Manual (Page 12)

12
11 Reboot and Factory Restore
a. Rebooting - Depress the reboot key for 2-3 seconds then release.
b. Restoring to Factory Default - Press the “Factory” button for 2-3 seconds then
release.
12 Close Camera
a. Once the field-of-view and focus have been verified, make sure all adjustment
screws and locks are firmly tightened.
b. Remove the analog test monitor RCA connection (if used).
c. Close the shroud by pivoting it back against the camera, while being careful
not to disturb the lens.
d. Position the dome cover so that the screws line up with the matching
receiving holes on the mounting plate.
e. Tighten the dome cover screws to the mounting plate with the supplied
Torx T-20 tool.
Reboot Factory
Figure 11.1