INTELLINET NETWORK 162470 Cat5e Wall-mount Patch Panel User Manual
Wall mount patch panel quick start guide
Are you completely satisfied with this product?
Please contact your
INTELLINET NETWORK SOLUTIONS
™
dealer with comments or questions.
Copyright © INTELLINET NETWORK SOLUTIONS
All products mentioned are trademarks or registered trademarks
of their respective owners.
www.intellinet-network.com
WALL
MOUNT
PATCH PANEL
QUICK
START
GUIDE
INT-PPWM-QSG-1206-02
Thank you for purchasing this INTELLINET NETWORK SOLUTIONS
™
Wall Mount
Patch Panel.
Follow the steps on this quick start guide for easy installation and use of either the
Cat5e or Cat6 version of this product.
T568A
P
IN
5 W
HITE
/B
LUE
P
IN
4 B
LUE
P
IN
1 W
HITE
/G
REEN
P
IN
2 G
REEN
P
IN
3 W
HITE
/O
RANGE
P
IN
6 O
RANGE
P
IN
7 W
HITE
/B
ROWN
P
IN
8 B
ROWN
T568B
P
IN
5 W
HITE
/B
LUE
P
IN
4 B
LUE
P
IN
1 W
HITE
/O
RANGE
P
IN
2 O
RANGE
P
IN
3 W
HITE
/G
REEN
P
IN
6 G
REEN
P
IN
7 W
HITE
/B
ROWN
P
IN
8 B
ROWN
1. Carefully strip away approximately 30 mm of the cable jacket(s) (above
left) to be connected to the Patch Panel, separating the wires into four
pairs. Using a wire cutter, cut the wire holder (above right) flush with the
cable jacket.
2. Follow the IDC
color-code chart
above to position
the wires, then use
a Krone punch-
down tool to crimp
and connect them.
approx. 30 mm
wire holder
IDC (3 options)
Krone
type
110D
type
110D & Krone
IDC compatible
12-port
Cat5e
UTP
model
shown