INSTEON MorningLinc (2458A1) Manual - Manual (Page 4)

MorningLinc Owner’s Manual
Page 4 of 9 2458A1 - Rev: 1/21/2014 8:44 AM
Installing MorningLinc
When installing MorningLinc, it is recommended to use an outlet or extension cord to keep the unit within
five feet of the door lock fixture. Once installation is complete, MorningLinc can be moved to another
outlet (up to 30 feet away from the door lock fixture).
MorningLinc can be used to control up to 15 Morning Industry deadbolts and door locks. However, each
door lock must be within 30 feet of MorningLinc.
1) Plug MorningLinc into an unswitched wall outlet.
The MorningLinc Status LED will turn on solid.
If the Status LED is not solid, tap MorningLinc’s Set button.
2) Use a screwdriver to remove the cover plate from the door lock fixture. Then, tap the door lock
fixture’s Set button (labeled “S”).
The door lock fixture will beep.
3) Tap MorningLinc’s Set button.
The door lock fixture will double-beep.
The MorningLinc Status LED will turn off.
4) If you wish to control multiple door locks with MorningLinc, repeat steps 3 and 4 with each additional
door lock fixture.