INSTEON LED Bulb 2672-222 Manual Rev.1.0-2.9 - Manual (Page 18)

18
1 2
Always-On Wiring
2
Remove the old switch and
disconnect the wires. If your box
lacks neutral wires, stop and
contact support.
1
3
Turn off power to your switch at the
electrical service panel.
ON ON
Circuit Breakers Fuse Panel
or
½”
12mm
Neutral Wire
!
Connect the Dimmer Switch wires to the identified wires in the junction box. The red load wire is
not used and, instead, capped. Verify that the wire nuts are secure and that no exposed copper
wire is visible except for the bare ground wire.
W
IKI
Neutral
Line
Load
Ground