B&K Precision 4079 - Manual - Manual (Page 59)

53
:SHAPe SINusoid|SQUare|TRIangle
:FREQuency
:SOURce INTernal |EXTernal
:FSK
[:STATe]
:LOWFrequency
:HIFrequency
:RATE
:SOURce INTernal |EXTernal
:SWEep
:STATe
:SPACing
:TIME
:STARt
:STOP
:PHAse
[:ADjust]
:PULSe
:PERiod
:WIDth
:EDGe
:RISe
:FALl
Note: For model 4079, nothing changes in the commands above to control channel 1. But for channel 2, change
:SOURce to :SOUR2. For example, to change channel 2 to SINE function, send the command: SOUR2:FUNC
SIN.
4.13.1.1 Frequency
:SOURce:FREQuency
The frequency command controls the frequency of the output waveform.
Arguments
Type: Numeric.
Units: MHz, KHz, Hz (default)
Range: Dependent on the Point Rate and Wavelength.
Fmax = 1/(8nS * Wavelength)
Fmin = 1/(100S * Wavelength)
Rounding: The value is rounded to 4 digits.
Command Type: Setting or Query
Setting
Syntax: [:SOURce]:FREQuency[:CW][units]
[:SOURce]:FREQuencyMINimum|MAXimum
Examples: :FREQ 5KHZ
:FREQ 5E3
:FREQ MAXIMUM
:FREQ MIN
Query
Syntax: [:SOURce]:FREQuency[:CW]?[MAXimum|MINimum]
Examples: :FREQ?
:FREQ? MAX
Response: NR3
Considerations:
1) The MIN | MAX arguments should be used only in a Program Message that does NOT contain Program Message