AEG HE604000H - Manual (Page 13)

INSTALLATION INSTRUCTIONS
Before the installation , note down the serial number (Ser. Nr.) from the rating plate.
The rating plate of the appliance is on its lower casing.
HE604000H 949 595 048 00
ME E0 005 220-240 V 50-60-Hz
7,0 kW
AEG
Safety instructions
WARNING!
You must read these!
Make sure that the appliance is not damaged because of transportation. Do not connect
a damaged appliance. If it is necessary, speak to the supplier.
Only an authorised servicing technician can install, connect or repair this appliance. Use
only original spare parts.
Only use the built-in appliances after you assemble the appliance into correct built-in
units and work surfaces that align to the standards.
Do not change the specifications or change this product. Risk of injury and damage to
the appliance.
Fully obey the laws, ordinances, directives and standards in force in the country where
you use the appliance (safety regulations, recycling regulations, electrical safety rules etc.)!
Keep the minimum distances to other appliances and units!
Install shock protection, for example install the drawers only with a protective floor di-
rectly below the appliance!
Keep safe the cut surfaces of the worktop from moisture with a correct sealant!
Seal the appliance to the worktop with no space between with a correct sealant!
Keep safe the bottom of the appliance from steam and moisture, e.g. from a dishwasher
or oven!
Do not install the appliance adjacent to doors and below windows! If not, when you
open the doors or windows they can push off hot cookware from the appliance.
WARNING!
Risk of injury from electrical current.
The appliances put together are live.
• Obey the electrical safety rules.
• The Rated voltage of the appliances put together must agree.
• Adjust the plug and socket connections together correctly.
• Install correctly to give shock protection.
• Loose and incorrect plug and socket connections can make the terminal become too hot.
• A qualified electrician must install the connections in the clamps correctly.
The appliance must have the electrical installation which lets you disconnect the appli-
ance from the mains at all poles with a contact opening width of minimum 3 mm.
You must have correct devices to isolate: line protecting cut-outs, fuses (screw type
fuses removed from the holder), earth leakage trips and contactors.
Installation instructions 13