Imetec RELAXY QUILTED DOUBLE DUAL - Manual (Page 8)

IT
6
parent or guardian or if the child has not been properly instructed on how to use the device safely.
• WaRnInG – noT suitable for children under the age of 3. children under the age of 3 must not
use the appliance due to their inability to react to overheating.
•
do noT activate the temperature control with wet hands.
•
do noT pull the power cord or the appliance itself to remove the plug from the socket.
• always disconnect the appliance from the mains supply before cleaning or performing maintenance
and when the appliance is not in use.
• If the appliance if faulty or malfunctions, switch it off and do not tamper with it. any repairs must only
be carried out by an authorised technical service centre.
• If the power cable is damaged it must be replaced by an authorised technical service centre, so as to
prevent all risks.
• The appliance must be used solely with the types of control indicated on the label.
•
do noT place the control unit under the pillow or between the sheets or bed covers when the
appliance is connected.
• check the appliance often for signs of wear and tear. If such signs are found or if the appliance has
been used incorrectly, contact an authorised technical service centre before continuing to use it.
• people with a pacemaker are recommended not to use the appliance all night long. The appliance can
be used to warm the bed but must be switched off and disconnected from the power supply before
going to bed.
•
do noT use on an adjustable bed: otherwise, verify that nor the blanket or the wire can remain
caught or blocked.
•
do noT tuck in.
• This appliance is not intended for medical use inside of hospitals.
•
do noT use the appliance if it is wet.
•
do noT use the appliance to keep animals warm.
•
DO NOT USE wHEN FOLDED OR IF CREASED.
•
do noT InsERT pIns oR nEEdlEs.
SYMBOLS
Protection class II Warning Prohibited actions
pREpaRaTIon
placInG ThE ElEcTRIc BlankET FIG. (a-B)
IMpoRTanT!
The electric blanket must only be placed between the mattress and the flat sheet and not on top of persons in bed.
• Lay the electric blanket directly on the mattress with the side on which there is the plug (1) facing the mattress.
• Make sure the electric blanket is always laid out properly.
• Lay the flat sheet on the electric blanket and then finish laying the bed as usual with a sheet and bed cover.
USE
connEcTInG and REMoVInG ThE TEMpERaTURE adJUsTMEnT conTRol FIG. (B)
IMpoRTanT!
The electric blanket must only be used with the control unit supplied. The relative model is specified on the label
sewn on the panel.
EN