AVSL 953.022 LS26 - Manual (Page 2)

Introduction:
Thank you for choosing this Citronic line splitter. The LS26 provides a reliable and comprehensive solution for line signal
distribution. In order to achieve the best results from this equipment and avoid damage through misuse, please read and follow
these instructions and retain for future reference.
Warning:
To prevent the risk of fire or electric shock, do not expose any part of the unit to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the line splitter
– refer all servicing to qualified service personnel.
Safety

Check that the supplied mains lead is in good condition and the supply voltage is correct.

Ensure signal leads are of good condition and connected to appropriate inputs/outputs

Do not allow any foreign particles to enter the unit through control or connector apertures
Placement

Keep out of direct sunlight and away from heat sources.

Keep away from damp or dusty environments.

When rack-mounting, avoid placing heavy units above the unit and ensure all connectors and controls are accessible
Cleaning

Use a soft cloth with a neutral detergent to clean the casing as required

Use a soft brush to clear debris from the control surface

Do not use strong solvents for cleaning the unit.
Front Panel
Rear Panel
6. CHANNEL A outputs 1 – 6 (6.3mm jack)
7. INPUT A (6.3mm jack)
8. MONO / STEREO mode switch
9. INPUT B (6.3mm jack)
10. CHANNEL B outputs 7 – 12 (6.3mm jack)
11. IEC mains inlet & fuse
12. Voltage selector
1. CHANNEL B volume controls (7 – 12)
2. SIGNAL B input clip indicator
3. MONO / STEREO mode indicators
4. SIGNAL A input clip indicator
5. CHANNEL B volume controls (1 – 6)