AVSL 952.979 AD-100 User Manual
Page 4
952.979UK User Manual
Connection and setup
Connect the rear outputs (17) to a line input on the mixer or mixer-amp using a twin RCA lead.
Extend the rear antenna (16) or in places of poor reception, replace this with an F connector lead to
a well sited aerial for better reception.
Connect the rear IEC inlet (18) to the mains using the supplied mains lead (or an equivalent
approved type). Ensure that the voltage is correct and that the mains outlet is switched on.
Press the power switch (1) to the ON position.
Select either DAB or FM mode (whichever preferred) using the MODE button (6) and press and hold
the centre of the rotary tuner (15) to initiate auto-scanning of available stations.
Access these stations using the preset memory keys (2)
Pressing the SHIFT key (3) increments the preset by +10
The rotary tuner can be used to manually tune frequencies and stations. This function is also
available using the UP/DOWN keys.
Pressing the centre of the rotary tuner confirms the current tuning selection, whilst pressing the
centre and holding initiates auto-scanning.
In FM mode, the stored stations can be listed in the LCD display by pressing the FM LIST button (14)
In DAB mode, the station information is carried along with the digital audio signal.
In FM mode, radio station information is carried by the Radio Data System (RDS).
The information shown in the LCD display can be changed using the INFO button (11)
The audio output may be muted indefinitely by pressing the MUTE button (4) and pressing this
button again will cancel the mute function.
Alternatively, the unit can be placed in sleep mode for a fixed period of time by pressing the SLEEP
button and using UP/DOWN keys to set the duration, after which the unit will automatically “wake”.