AVSL 170.860 CL1002 - Manual (Page 2)

Introduction:
Thank you for choosing this Citronic CL/CLP series mixer. This product has been designed to offer reliable, high quality mixing
for stage and/or studio applications with unfailing consistency. In order to gain the best results from this equipment and avoid
damage through misuse, please read and follow these instructions and retain for future reference.
Warning:
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on the surface, stop using immediately, allow unit to dry out and have checked by qualified personnel before
further use.
Avoid impact, extreme pressure or heavy vibration to the unit.
There are no user serviceable parts inside the mixer
– refer all servicing to qualified service personnel.
Safety

Check that the supplied mains lead is in good condition and the mains supply voltage is correct.

Ensure signal and speaker leads are of good condition – ensure that there are no shorted connections

For CLP models, ensure that the minimum combined speaker load for each channel is 4 Ω

Do not allow any foreign particles to enter the console through connectors, control apertures or vents

Do not cover or obstruct cooling vents
Placement

Keep out of direct sunlight and away from heat sources.

Keep away from damp or dusty environments.

When rack-mounting, use rack ears supplied, securing firmly.

Ensure adequate access to controls and connections

Ensure adequate air-flow for cooling
Cleaning

Use a soft cloth with a neutral detergent to clean the casing as required

Use a soft brush to clear debris from the control surface and vents

Do not use strong solvents for cleaning the unit.
SPECIFICATIONS CL1002 CLP1002
Power supply 220-250Vac, 50Hz
Inputs : Mic/Line 6 x balanced XLR/6.3mm jack
Phantom power +48V to XLR inputs (switchable)
Inputs : Line 2 x stereo L+R 6.3mm jack, 2-track in (L+R RCA)
Input sensitivity Mic -60dB, Line -45dB
THD ≤0.05%
S/N ratio ≥95dB
Frequency response 20Hz - 20kHz
Effect presets 16 x DSP reverb/delay algorithms
Output : Mix 2 x balanced XLR/6.3mm jack + Rec. out (L+R RCA)
Auxillary output Aux send and return (6.3mm jack)
EQ controls Channel High, Mid, Low + master 7-band graphic
Power rms : 4 Ohms N/A 2 x 350W
Power rms : 8 Ohms N/A 2 x 250W
Speaker outputs N/A 2 x SPK connectors
Dimensions 510 x 100 x 455mm 510 x 150 x 480mm
Weight 6.37kg 12.38kg