Knape&Vogt BIF-50A Series - Manual (Page 3)

4
5
HANG DooRS
ADjuSt AND FINISH
• Fold door panels together and engage top pivot guide of pivot door into track pivot. (1)
• Set bottom pivot assembly into pivot bearing in jamb bracket. (2)
• Slide carrier bolt into top mount plate slot. (3)
• Screw snubber onto track in location based on number of doors.
• Install finish trim or casing.
• Move top pivot bracket in our out to adjust side clearance.
Vertical Adjustment 2:
Rotate adjusting bolt on bottom pivot.
Turn right to lower door and left to raise.
Vertical
Adjustment 1:
Use wrench to
rotate carrier
bolt. Turn right to
raise and left to
lower. Adjust so
weight is evenly
distributed
across the top
of the track for
smooth and
even folding
action.
Horizontal Adjustment:
To adjust tilt, slide jamb
bracket pivot bearing
in or out and tighten
in place.
Aligners (4-Door oNLY):
Mount aligners on the back side
of door panels. Use aligners as
template and drill 3/32" diamter
holes and secure with (#8 x 3/4")
screws. (P)
Rear
Arrière
Rear
SLIDING DooR HARDWARe - BI-FoLD Assembly
Instructions
#310298_C (1013)
Pivot
Pivote
Guide
Guía
1
2
3
Snubber Location
2-Door: Between top guide and side jamb furthest from the pivot.
4-Door: Between the pairs of door panels.
Note: Fasten finish header trim to either header OR wall, but not both,
so header can be removed later without damage.
1/2"
(1,3 cm)