Ingalls 35300 User Manual
Ingalls For the car
Installation Instructions
1.
Record and document initial reading alignment readings.
2.
Raise vehicle and remove wheel.
3.
Mark position of original cam bolt.
NOTE: Replace one cam bolt assembly at a time.
4.
Remove nut, washer and cam bolt.
5.
Install new cam bolt in the same position as old bolt.
6.
Install new nut and washer and tighten slightly.
7.
Repeat steps 3 thru 8 for other cam bolt assembly.
8.
Lower vehicle and continue with alignment.
9.
Check and adjust toe.
ING3530-72897
Copyright © 1997-04 Ingalls Engineering Co., Inc.
CHEVROLET CORVETTE (REAR)
Cam bolt assembly
located on upper
control arm at inside
mount.
Replace one bolt at
a time.
CHRYSLER PRODUCTS
CAM BOLT
Cam bolt assembly located on lower control arm at inside mount.
FORD PRODUCTS
To release spring
tension place a
wedge between the
upper control arm
and the front cross
member
- 40000 Series (1 page)
- 93037 (3 pages)
- 93300 (2 pages)
- 93043 (3 pages)
- 39209 (2 pages)
- 35220 (1 page)
- 38930 (1 page)
- 93180-93181 (3 pages)
- 26128 (1 page)
- 93184 (2 pages)
- IK500033RDX (1 page)
- 35590-35622 (1 page)
- 35150 (1 page)
- 54300 (1 page)
- 38500 (1 page)
- 38420 (1 page)
- 23220 Series (1 page)
- 35623 (1 page)
- 38300-38320 (1 page)
- 35200 (1 page)
- 38600-38620 (1 page)
- 93029 (3 pages)
- 35180 (1 page)
- 38950-38970 (2 pages)
- 35750-35780 (1 page)
- 93038 (2 pages)
- 38525 (3 pages)
- 29600 (1 page)
- 43500 Series (1 page)
- 38200-38220 (1 page)
- 38250-38270 (1 page)
- 93040 (3 pages)
- 38940 (1 page)
- 53200 (1 page)
- 93055 (2 pages)
- 93045 (3 pages)
- 81250-81290 (1 page)
- 26126 (1 page)
- 38955-38975 (2 pages)
- 26125 (1 page)
- 29700 (1 page)
- 93046 (2 pages)
- 38980 (2 pages)
- 35640-35650 (1 page)
- 35850-35860 (1 page)