Atdec Telehook TH-PPA-2448 Installation manual - Manual

Step 2. Configurations
TH-PPA-24-48
Component Checklist
! IMPORTANT - Install Telehook Adjustor Pole as per installation instruction.
! This product supports a maximum load of 454kg (1000lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received all parts against the component checklist and hardware above.
Adjustor Pole Plastic Cover Extension Pole HARDWARE
Security Set Screw
(x2)
Set Screw
(x2)
Standard Socket Pan Head
Screw (x1)
4mm Security Allen Key
Security Socket Pan Head
Screw (x1)
2.5mm Allen Key
Existing Ceiling
Plate Bracket.
Sold seperately
and available from
ATDEC.
2.1. Configure components as per image below for a pole length of
24”.
2.2. Screw Extension Pole in a clockwise direction into Ceiling Plate
Bracket.
Extension Pole
2.3. Configure components as per
shown below for a pole length range of
26-48”.
2.4. Screw Extension Pole in a clockwise
direction into Ceiling Plate Bracket.
2.5. Locate Adjuster pole on Extension
Pole aligning the holes with the slot.
Adjuster Pole
24” Range 26-48” Range
Existing Ceiling
Plate Bracket
Slot
Holes
Installation Instructions
24-48” (610-1220mm) Adjustable Projector Pole Accessory
Extension Pole