M&C TechGroup MP26-H1 Data sheet - Manual

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany
[email protected] • www.mc-techgroup.com • Fon +49 2102 935-0 • Fax +49 2102 935-111
10.8
Embracing Challenge
ƒ ƒ
Heated up to 180 °C
ƒ ƒ
Corrosion resistant
ƒ ƒ
With excess temperature limit switch
ƒ ƒ
Alarm function for temperature
failure
ƒ ƒ
100% lubricant free
ƒ ƒ
Gas tight
ƒ ƒ
Maintenance free
ƒ ƒ
Long service life
Special Features
Analytical Diaphragm Pump
Series MP®
Version MP26-H1 heated at 180 °C
MP26-H1
Application
This M&C-pump MP26-H1 is suitable for cor-
rosive gases. It is constructed especially for
hot gas analysis technique.
Description
The M&C-pump MP26-H1 has an electrically
heated head out of PTFE. The temperature is
controlled by an integrated compact capillary
sensor thermostat with an excess tempera-
ture limit switch and an alarm function for
temperature failure. All sample contacting
parts are made out of PTFE, the diaphragm
mounting disc is out of nickel-plated stain-
less steel.
The pump works absolutely lubricant free, so
gases remain analytically unchanged. Due to
a special diaphragm and valve system, the
pump operates maintenance-free.
In order to guarantee an operation without
interferences, it is important to pay attention
to the permissible overpressure. Therefore
you must decrease or regulate the quantity of
gas via a needle valve on the sucking side or
via a pressure control valve or bypass on the
pressure side.
Technical specifications and illustrations are without
obligation, subject to modifications. 09.96/11.06