T-up, Start-up – Acura 2013 RDX Navigation User Manual
Page 21
20
Syst
em Se
tup
Start-up
The navigation system starts automatically when you set the power mode to
ACCESSORY or ON. At start-up, the following Confirmation screen is displayed.
1. Move
y to select CHANGE
LANGUAGE.
If you do not need to change
the system language, proceed to
step 3.
2. Rotate
i to change the system
language. Press
u.
3. Press
u to select OK.
Your current position is
displayed on the map screen.
If you have set any calendar
event reminders, they are
displayed. Proceed to step 4.
1
Start-up
If the navigation system loses power at any time,
you may need to press and hold the VOL
9
(Volume/Power) button for more than two
seconds, or you may be prompted for the five-
digit security code.
2 System Initialization P. 230
At start-up, the driver’s fob key is automatically
detected and the address book settings, setup
preferences, wallpapers, and audio settings for
that driver (e.g., Driver 1) are loaded.
AcuraLink® Message Icon
If you have any unread messages, the
(AcuraLink® message) icon is displayed at the
bottom left side of the screen.
You can change the system language at any
time.
“OK” on the Confirmation screen cannot be
selected by using a voice command. If you do not
press
u within 30 seconds, the screen goes
blank (or displays your wallpaper screen and you
cannot use voice commands). Press any
navigation or voice control button to continue.
RDX_KA-31TX4800.book Page 20 Monday, January 30, 2012 11:32 PM
QRG
2013 RDX Navigation