Acura Embedded AcuBrite 12″-Nav - Manual (Page 2)

AcuBrite 12-NAV User Guide AcuBrite 12-NAV User Guide
CONNECTIONS AND CONTROL FEATURES
Rear connections
1.Fuse 2. Power Input 3. DVI Input 4. VGA-Input 5. RS232 Input
6. CVBS-1,2,3 Input (Composite Video ) AV Input 7.USB for Touch control
This monitor is designed to run on marine vehicle’s power systems, with 9~36V DC
wide range power input.
You must ground the monitor by connecting the drain wire (shield) of the
power input. It is important that an effective radio frequency (RF) ground is
connected to the monitor.
Power connections
The power connection to the monitor
should be made at either the output of
the battery. isolator switch, or at a DC
power distribution panel. AcuBrite 12-
Nav recommends that power is fed
directly to the monitor via its own
dedicated cable system and MUST be
protected by a thermal circuit breaker
or fuse, fitted close to the power
connection. If you do not have a
thermal circuit breaker or fuse in your
power circuit, you MUST fit an in-line
breaker or fuse to the positive (red)
lead of the power cable.
3 2
1 2 4 6 7 5 3