Acura Embedded AcuTouch 15″ - Manual (Page 4)

AcuTouch™ Manual User’s Manual
Installation
1. Turn power off for both Computer and Display before
making any connection.
2. Connect the power cable (12v AC/DC adapter or 8v –
30v DC).
3. The LCD monitor comes with a 15-pin video cable; you
may use this cable for both IBM PC’s & compatibles and
Macintosh.
4. Tighten the screws of the Display cable until the
connectors are fastened securely.
5. Switch on power to the monitor, then to the computer
system. Red LED should be on when only the monitor is
powered on and green LED should be on when both
monitor and computer are powered on.
The following picture provides the connection outline
Page 3
With Cables:
The Display Timing
Mode Resolution
VGA 640x480 @60Hz
640x480 @72Hz
640x480 @75Hz
SVGA 800x600 @56Hz
800x600 @60Hz
800x600 @72Hz
800x600 @75Hz
XGA 1024x768 @60Hz
1024x768 @70Hz
1024x768 @75Hz
SXGA 1280x1024 @60Hz
1280x1024 @70Hz
1280x1024 @75Hz
WXGA 1366x768 @60Hz
WSXGA+ 1680x1050 @60Hz
SXGA+ 1400x1050 @60Hz(Pixel f 101.000MHz)
1400x1050 @60Hz(Pixel f 121.750MHz)
1400x1050 @75Hz
UXGA 1600x1200@60Hz
1600x1200@65Hz
1600x1200@75Hz
Page 4
DC 8~30V
Input
USB port DC +12V Input
To computer
VGA
USB port Touch controller can
use RS232 port or
USB port
To device