Activeforever Teeter Hang Ups EP-550 Inversion Table - Manual (Page 7)

A B C
Step 3
Install the Roller Hinges (F5-1064) onto the Table Bed (EP-1140)
• For ease-of-assembly, rest the Table Bed against the side of the A-frame (Figure 5).
• Open the Cam Locks on each side of the Table Bed (Figure 5A).
• With the Pivot Pins facing outward, insert the Roller Hinges into the brackets on each side of the
Table Bed. The Roller Hinges must slide between the Cam Locks and the brackets.
• Make sure the Roller Hinges are in the same hole setting on both sides. Figure 6 shows the Roller
Hinges engaged correctly in setting C.
• Push down on the Cam Locks (Figure 6A) to secure the hinges.
NOTE: Refer to the Owner’s Manual for an explanation of the hole settings. If you are unsure, use
setting C to start.
Figure 6A Figure 6
Pivot Pin
Cam Lock
Figure 5A
Figure 5