Activeforever PAL 1000 Portable Aquatic Pool Lift - Manual (Page 5)

4
All PAL and Splash! Products – Standard Components in all Units
Control Box. Forms the bottom of the control console; this unit controls the
mechanical operations of the lift. Three wire leads connect to the rear of the
Control Box. The largest receptacle is the connection for the Hand Control.
The connector next to the hand control connector, marked number 1, is the
receptacle for the Actuator lead. The connector next to the actuator connec-
tor, marked number 2, is the receptacle for the 24-volt motor lead.
Battery. The removable battery is located on top of the con-
trol box. The battery should be charged daily. Do not allow
battery to fully discharge, as this would shorten the life of
the battery.
Battery Cover. The provided nylon battery cover should be
placed over the battery when the system is in use.
Hand Control. Initiates the actions of the lift. The two top
buttons control the lifting actions of the unit. The bottom
pair of buttons controls the side to side movement of the
lift. The right button turns the main mast to the right, and
the left button turns the main mast to the left.
Mast. This vertical piece is bolted to the base assembly.
Actuator. Attached to the top of the mast, this part powers the up and
down movements of the lift.
Rotation Motor Assembly. Consists of mounting plate, 24-volt motor,
and small gear.
Hub Assembly. Consists of hub, bearings, shaft, large gear and mast
mounting plate.
Horizontal Support Arms. These two support arms connect the mast to
the chair support arm. The longer horizontal support arm (actuator arm)
connects to the actuator and initiates the lifting movements.
Chair Support Arm. Connects the chair to the horizontal support arms.
PAL PRODUCT COMPONENTS
REFER TO THE DIAGRAM ON PG.7 FOR COMPONENT IDENTIFICATION.