FIAT 600 - Manual (Page 93)

92
IN AN EMERGENCY
5) Lower the car and remove the
jack.
6) Torque the screws in the order
described above fig. 8.
After refitting the wheel:
– place the spare wheel in its recess
in the boot and fasten it with the ring
nut A-fig. 3;
– put the jack in its bag and place this
in the replaced wheel.
IMPORTANT Tubeless tyres are
used.
Check the inflation pressure of the
tyres and the spare wheel regularly.
fig. 9
P4Q00099
8) Ensure that the housings for the
wheel bolts on the spare wheel are
clean and free from dirt which could
cause the wheel bolts to come loose.
9) Fit the space-saver spare wheel
making peg A-fig. 7 coincide with one
of the holes B on the wheel.
10) Screw the four fastening bolts.
11) Wind down the jack to lower
the car and remove the jack.
12) Fully tighten the bolts moving in
a criss-cross fashion following the or-
der shown in fig. 8.
REFITTING THE STANDARD
WHEEL
1) Following the above procedure,
raise the car and remove the space-
saver wheel.
2) Refit a regular wheel inserting the
first bolt A-fig. 6 in the hole opposite
the inflation valve.
3) Fit the wheel cap ensuring symbol
Y A-fig. 9 corresponds with the in-
flation valve and the previously fixed
bolt B.
4) Insert the other three bolts and
screw them using the specific wrench.
fig. 7
P4Q00203
fig. 8
P4Q00204