Yamaha RX-V592 - Manual (Page 46)

44
1
* If there is no operation for about 30 seconds after the
MACRO button is pressed, the TRANSMIT/LEARN
indicator flashes rapidly and the mode before you pressed
the MACRO button is restored. If this occurs, press the
MACRO button again.
2
Press a preset macro key on which you want to make a
new macro.
* If a key other than a preset macro key is pressed, the
TRANSMIT/LEARN indicator flashes rapidly and the current
mode is canceled. If this occurs, repeat this step.
3
Press a key whose function you want to store as the first
function of the new macro.
* If a key whose function cannot be stored as a command of
macro is pressed, the TRANSMIT/LEARN indicator flashes
rapidly and the current mode is canceled. If this occurs,
repeat this step.
* If about 30 seconds pass before a key is pressed, the
TRANSMIT/LEARN indicator flashes rapidly and the mode
before you began learning operations is restored. If this
occurs, restart from step 1.
4
Repeat step 3 to store the second, the third and more
functions. You can store up to seven key functions in
series as a macro.
* If the seventh key function has been learned, the
TRANSMIT/LEARN indicator flashes rapidly and the mode
before you began learning operations is restored. (This
shows that the key has completed learning a series of
functions as a macro.) If this occurs, you do no have to
follow the next step.
5
When you finish learning, press the MACRO button.
MAKING A NEW MACRO
A new macro can be programmed onto any preset macro key in place of preset functions. (See page 41 to know what keys are
preset macro keys.) You can make as many as 13 new macro keys. A macro key can learn as many as seven functions of other
keys.
Note
If you store a continuous command such as lowering of volume level, it will become a short command when it is carried out as a part
of macro.
LEARN CLEAR MACRO
It is recommended to write down new key functions you
stored on the provided user function stickers and paste
them on the reverse side of the remote control transmitter
or the reverse side of the remote control transmitter’s lid.
Memory back-up
All of the learned functions will be retained while you
replace the batteries. However, if no batteries are
installed for a few hours, the learned functions will be
erased and will have to be learned again.
Goes off.
(When learning is finished,
this indicator lights up again.)
TRANSMIT
/LEARN
LEARN CLEAR MACRO
Flashes slowly.
CD TRANSMIT
/LEARN
Lights up.
SYSTEM
POWER TRANSMIT
/LEARN
A
B
C
REMOTE CONTROL TRANSMITTER