Specifications – Yamaha R CD-S700 User Manual
Page 24
TROUBLESHOOTING
20
En
Audio Section
• Frequency response......................................2 Hz - 20 kHz, ± 0.5 dB
• Harmonic distortion + noise (1 kHz) .........................0.002 % or less
• S/N ratio .................................................................... 110 dB or more
• Dynamic ................................................................... 100 dB or more
• Output voltage (1 kHz, 0 dB)........................................... 2.0 ± 0.3 V
Laser Diode Properties
• Material ................................................................................. GaAlAs
• Wavelength ............................................................................ 790 nm
• Laser Output.............................................................. max. 1.23
μW*
* This output is the value measured at a distance of about 200 mm
from the objective lens surface on the Optical Pick-up Block.
General
• Power requirements
U.S.A. and Canada models...............................AC 120 V, 60 Hz
Australia model ................................................AC 240 V, 50 Hz
Europe and U.K. models .......................... AC 220-240 V, 50 Hz
Asia and General models.......AC 110-120/220-240 V, 50/60 Hz
Korea model .....................................................AC 220 V, 60 Hz
China model......................................................AC 220 V, 50 Hz
• Power consumption ................................................................... 16 W
• Dimensions (W × H × D) ................................... 435 Ч 96 Ч 300 mm
• Weight ......................................................................................6.2 kg
Please note that all specifications are subject to change
without notice.
The remote control
does not work or
function properly.
Wrong distance or angle.
The remote control functions within a
maximum range of 6 m (20 ft) and no more than
30 degrees off-axis from the front panel.
Direct sunlight or lighting (from an inverter type
of fluorescent lamp, etc.) is striking the remote
control sensor of this unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
SPECIFICATIONS
Problems
Possible Causes
Solutions
Refer to
page