Yamaha RC-SREV1 - Manual (Page 9)

RC-SREV1 Rear Panel
7
RC-SREV1—Owner’s Manual
Fader status —The status of each fader appears along the bottom of the display. For
pages selected with the [PARAMETER MAIN] button, the names of the parameters
assigned to the faders appear, and for pages selected with the [PARAMETER FINE]
button, the channel names appear, as shown below.
RC-SREV1 Rear Panel
A POWER switch
This switch is used to turn on the power to the RC-SREV1. Power is supplied by the
SREV1 via the remote cable, or an optional AC adapter. See “Turning On & Off the
RC-SREV1” on page 8 for more information.
B DC 12V IN connector
An optional AC adapter can be connected here (necessary when a custom-made remote
cable is used). See “Using an Optional RC-SREV1 AC Adapter” on page 8 for more
information.
C Adapter cable clip
This clip is used to secure the optional AC adapter’s cable in order to prevent accidental
disconnection. See “Using an Optional RC-SREV1 AC Adapter” on page 8 for more
information.
D REMOTE port
This 9-pin D-sub connector is used to connect the RC-SREV1 to the SREV1 with the
remote cable supplied with the RC-SREV1. See “Connecting the RC-SREV1 Remote
Controller” on page 22 of the SREV1 Owner’s Manual for more information.
E BRIGHT control
This control is used to adjust the brightness of the display. See “Adjusting the
RC-SREV1 Brightness & Contrast” on page 9 for more information.
F CONT control
This control is used to adjust the contrast of the display. See “Adjusting the RC-SREV1
Brightness & Contrast” on page 9 for more information.
Parameter
Channel
1 2 3 4 5 6
BRIGHT CONT
LCD REMOTE DC 12V IN POWER
ON OFF