beautypg.com

Suspended and bracket installation, Suspended installation, Bracket installation – Yamaha C115V User Manual

Page 6

background image

6

Suspended and Bracket Installation

Suspended Installation

The C112VA and C115VA can be used in suspended “flying”
rigs by using an appropriate suspension wire.

1. Replace the bolts with the supplied eyebolts (3/8") as shown

in the diagram, and then suspend the speaker using an
appropriate wire.

2. The speaker angle can be adjusted for optimum coverage by

adjusting the lengths of the suspension wires, but the down-
ward tilt angle must be less than 45 degrees, as shown in the
diagram.

Bracket Installation

The C112VA has bracket-mounting screws on the top, bottom,
and sides of the speaker enclosure. The C112VA can be
mounted on a wall or ceiling using the optional brackets listed
below.

• Consult an installation expert to arrange for installation or construction work.
• Choose suspension wire, an installation location, and mounting hardware that are strong enough to support the

weight of the speaker.

• Some fittings may deteriorate over extended periods of time due to wear or corrosion. For safety the installation

should be checked thoroughly at regular intervals.

Yamaha cannot be held responsible for damage or injury caused by insufficient strength of the support structure or improper
installation.

• Use only the supplied eyebolts.
• Use two or more eyebolts for suspended installa-

tion. Always use the eyebolts marked

.

• Do not suspend a speaker from another suspended

speaker.

Bolts

Bolts

Eyebolts

Eyebolts

Maximum
45

Degrees

Bracket

Model

Wall bracket

BWS251-300, BWS251-400

Ceiling bracket

BCS251

Baton bracket

BBS251

• Use only the specified screws (W5/16")

to attach the bracket to the speaker.
The mounting screws are installed on the speaker
when it leaves the factory. Refer to the instruc-
tion manual supplied with your bracket for
installation details.

Screws (W5/16")

This manual is related to the following products: