Display information during programming, A - 1 – Yamaha CDC-697 User Manual

Page 24

When you finish the programming for side A,
program the pause mode by pressing the TAPE
button.

* “PAUSE” lights up in the display.

Repeat steps 5 and 6 to program more tracks
for side B of the tape.
You can select the same track again.
* If “ERROR” appears in the display, the track number

just selected cannot be programmed because there is
no enough time remaining on side B of the tape.

Start recording on the tape deck and press the
w

button at the same time.

The unit will pause at the end of side A of the
tape. Turn the tape over to side B. Resume
recording and, at the same time, press the w or
d

button.

Notes

• In steps 7 and 9, even if “ERROR” appears in the display, you

can program another track of which time is shorter than the
remaining time on the side of the tape. At this time, if any
other track number lights up in the display, you can program
it.

• CD synchronized recording function can be used if your tape

deck is compatible with it.
In this case, in steps 10 and 11, press the

SYNCHRO button

and then press the w button. Recording automatically starts.
(For details, refer to page 17.)

Notes on tape programming

•

You can check, cancel or correct program data. (For
details, refer to page 14.)

•

The maximum number of tracks that can be programmed
is 40. If, however, the PAUSE mode is inserted, it is
counted as one track.

•

This function can be used to program up to track number
20. If the disc has more than 20 tracks, tracks with track
number 21 and higher cannot be programmed.

TRACK PROGRAMMING FOR RECORDING

TAPE

■ Display information during

programming

1 Shows the side of the tape and the program number for

the track to be programmed next.

2 Shows the selected disc and track number.
3 Shows the total remaining time on the side of the tape.
4 Programmed track numbers light up and programmable

track numbers among the unprogrammed ones blink.

* If “A-1” does not appear in the display after the

PROG

button is pressed, press the

TEXT/TIME display mode-

select button.

* If, during programming, the

TEXT/TIME display mode-

select button is pressed, the program number display can
be changed to display the total remaining time on the
side of the tape. To return to the previous display, press
the

TEXT/TIME display mode-select button once again.

- -

A -

1 2 3 4 5

1DISC

5DISCS

TITLE

REP RNDM SAVE BEST EDIT FILE

S F

PROG

CD- TEXT

ARTIST

TRACK

1 2 3 4 5
6 7 8 9 10

11 12 13 14 15
16 17 18 19 20

8 :

2 8