Yamaha DVD-S830 - Manual (Page 19)

R
Q
T6
797
19
See page 18 for menu and option details.
1
Press [SET UP] to show the menus.
≥ The QUICK SETUP screen appears when you press [SET UP] the
first time after purchase (
➡ page 8).
2
Press [ 2 , 1 ] to select the menu’s tab.
The screen changes to display the menu.
3
Press [ 3 , 4 ] to select the item you want to
change and press [ENTER].
4
Press [ 3 , 4 , 2 , 1 ] to select the option and
press [ENTER].
The screen now shows the menu again.
To return to the previous screen
Press [RETURN].
To exit the SETUP menu
Press [SET UP].
[DVD-V]
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
≥ If you enter a wrong number, press [CANCEL] to erase it.
2. Press [ENTER].
≥ The lock symbol appears closed to show the rating is locked.
≥ Do not forget your password.
3. Press [ENTER] to confirm the 4 digits.
[DVD-A] [DVD-V]
Change the settings when you have connected equipment through this
unit’s DIGITAL OUT terminal (OPTICAL or COAXIAL).
Select whether to output digital signals or not.
≥ On: Digital signals are output.
≥ Off: Digital signals are not output.
Select how to output audio with a sampling frequency of 96 kHz or
88.2 kHz.
≥ Select “Yes” if the equipment you connect cannot process signals with a
sampling frequency of 96 kHz or 88.2 kHz.
Also make the appropriate “Digital Audio Output” setting ( ➡ above).
No (Factory preset): Output as 96 kHz or 88.2 kHz
Yes: Converted to 48 kHz or 44.1 kHz
[Note]
≥ Signals are converted to either 48 kHz or 44.1 kHz despite the above
settings if the signals have a sampling frequency of over 96 kHz, or the
disc has copy protection.
≥ Some equipment cannot handle sampling frequencies of 88.2 kHz, even
if they can handle 96 kHz. Read your equipment’s operating instructions
for details.
Bitstream (Factory preset for Dolby Digital):
Select if the equipment you connected can decode the signal.
PCM (Factory preset for DTS Digital Surround and MPEG):
Select if the equipment you connected cannot decode the signal.
IMPORTANT
If the equipment you connected cannot decode the signal, the
setting must be changed to PCM. If not, signals the equipment
cannot process will be output by this unit, causing high levels of
noise which can damage your hearing and the speakers.
Common procedures
Disc
(---)
Video
(---)
Audio
:
;
:
;
Others
(------------------------------------------------------)
Display
RETURN
SET UP
CANCEL
3 , 4 , 2 , 1
ENTER
Numbered
buttons
Disc
SELECT
Audio
Subtitle
Menus
Ratings
English
English
Automatic
Level 8
SETUP
TAB
Entering a password (Ratings)
Digital output
Digital Audio Output
PCM Down Conversion
Dolby Digital, DTS Digital Surround and MPEG
Now, when you insert a DVD-Video that exceeds the ratings limit you
set, a message appears on the television.
Follow the on-screen instructions.