Walker MDD - Manual (Page 6)

4
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
Use only genuine Walker ® replacement parts. Effective Date 03-01-06
BODY / CHASSIS ASSEMBLY (GHS MODELS)
Seat Assembly
1 5103 Seat 1
2 7203 Seat Spring Plate 1
3 7223 Compression Spring (1/2 x 1) 2
4 7845 Rubber Bumper (1.375 OD x .63) 2
5 7846 Washer (3/8 ID x 1-1/4 OD x 1/8) 2
6 7204 Shoulder Bolt, Seat Mount 2
7 7440-5 Shock Mount (1-1/4 x 3/4) 2
Rear Bumper Assembly (GHS Models Only) *
8 NS Recovery Tank Mount 1
(19449-72502 Kubota)
9 7047-5 Mount Plate 1
10 7516-7 7.0 / 9.5 Rear Bumper 1
11 7516-5 Catcher Pivot Bushing 2
12 5162 Roller Wheel (5" Rubber) 2
13 7517-2 Catcher Pivot Plate 2
14 5832 Cable Clamp (1/2) 2
Body Assembly
15 NS Body ID Plate 1
16 5845 Rubber Bumper (1.50 OD x 1.25) 4
17 7422 Panel Guard 1
18 5989-4 Dome Plug (3/8) 4
19 5989-3 Dome Plug (5/16) 2
20 7146 13mm Ball Stud 2
21 7844 Rubber Bumper (1.25 OD x .25) 1
22 7147 Spring Clip 2
23 7145 Gas Spring Assembly 1
(Includes Items # 20 & 22)
24 7222 Extension Spring (1/4 x 3) 1
25 7383-2 Body Latch Hook 1
26 7854 Plastic Tip, Red 1
27 5989-9 Dome Plug (1/4) 8
28 7100 Front Body 1
29 5180 Edge Molding, Lever Opening 2
30 5989-55 Dome Plug (1/2) 1
31 5989-5 Dome Plug (7/16) 1
Tilt-Up Latch Assembly ***
32 5847 Plastic Tip 1
33 5744-20 Spring Arm, Tilt-Up Latch 1
34 5744-10 Spring Pivot Bushing 1
35 5744-15 Compression Spring (3/8 x 5/8) 1
36 5744-13 Mount Angle, LH 1
37 5744-12 Hook, Tilt-Up Latch 1
38 5744-14 Mount Angle, RH 1
Chassis Assembly
39 5267-1 Retainer Collar (1") 1
(Includes Item # F413)
40 5270-1 Pivot Bearing 2
41 7420 Tail Wheel Fork 1
42 5830-3 Grease Fitting (45 Degree) 2
43 8039 Nut, Tail Wheel Axle 2
44 8037-1 Seal, Outer (1-3/4 x 1-1/8) 2
45 8038-1 Spacer, Tail Wheel Axle 2
46 8037 Bearing Cone (3/4 ID) 4
47 8037-2 Bearing Race 4
48 8035 Tail Wheel & Tire (13 x 5.00-6) 2
(With Bearing Race)
7035-1 Tail Wheel Tire (13 x 5.00-6) **
8036 Tail Wheel & Hub (6 x 3.25) **
(Includes Items # 41 & 47)
7420-20 Dual Tail Wheel & Tire Assembly **
(Includes Items # 43-46 & 48-50)
49 8768-2 Seal, Reverse Lip 2
50 8038 Tail Wheel Axle (3/4 x 10-3/8) 1
51 7070 Wheel & Tire (18 x 9.5-8) 2
7070-1 DriveTire (18 x 9.5-8) **
5070-4 Wide Wheel (8 x 7) **
52 7300-5 Chassis Frame 1
Fasteners
F002 10-24 Keps Nut 2
F004 1/4-20 Keps Nut 6
F005 1/4-20 ESNA Nut 1
F009 5/16-18 Whiz Locknut 13
F012 3/8-16 Keps Nut 8
F013 3/8-16 Whiz Locknut 2
F014 3/8-16 ESNA Nut 4
F020 5/16-18 ESNA Nut 1
F026 10-24 x 1/2 PPHMS 2
F029 1/4-20 x 1/2 Hex Bolt 2
F031 1/4-20 x 5/8 Hex Bolt 1
F034 5/16-18 x 3/4 Hex Bolt 2
F038 3/8-16 x 1 Hex Bolt 6
F040 3/8-16 x 1-1/2 Hex Bolt 2
F042 3/8-16 x 2-1/4 Hex Bolt 2
F050 1/4 SAE Washer 1
F051 3/8 SAE Washer 2
F059 3/8 Wave Spring Washer 2
F093 5/16-18 x 1 Hex Bolt 1
F104 1/4-20 x 3/4 PFH Bolt 4
F151 3/8-16 x 7/8 Hex Bolt 2
F157 1/2-20 x 1-1/4 Wheel Lug Bolt 8
F205 5/16-18 x 1/4 Set Screw, Knurl Point 2
F206 #2 x 3/16 Drive Pin 2
F218 7/16 Split Lock Washer 2
F219 7/16-14 x 1-1/4 Hex Bolt 2
F227 3/8 x 1-1/4 x 1/8 Plastic Washer 2
F241 .375 x .875 x .10 Washer 4
F341 Coil Roll Pin (7/64 x 9/16) 1
F342 5/16 Conical Washer 2
F413 5/16-24 x 5/16 Set Screw 2
* Rear Bumper Assembly for SD Models is not shown here.
Refer to BODY ASSEMBLY (SD MODELS), Page 8.
** Service Part Only
*** Complete Tilt-Up Latch Assembly Kit available by ordering
kit # 5747.