WatchGuard Technologies WatchGuard SOHO and SOHO | tc - Manual (Page 40)

Troubleshooting installation and network configuration
28
C AUTION
This is a major security risk. For instructions on how to allow any
incoming services, refer to “Adding the Any service” on page 38
How do I allow incoming IP protocols?
You will need the IP address of the computer that will be receiving
the incoming data and the IP protocol number that corresponds to
the specific incoming IP protocol. To allow an incoming IP
protocol:
1 Using your Web browser, go to http://192.168.111.1.
2 Click Services and then click Allowed Incoming Services.
3 Click Add a Service and then click Add Other Service.
4 In the protocol field, enter the protocol to allow.
5 Enter the IP address of the computer to receive incoming data
for that protocol. Click Submit.
How do I set up and disable Web blocking?
1 Using your Web browser, go to http://192.168.111.1.
2 Click Services and then click Web Blocking.
3 Enable the checkbox labeled Enable Web Blocking. Enter a
password, time limit per session for your password, and enable
the checkbox next to the type of sites you want blocked.
To disable Web blocking, disable the checkbox labeled Enable Web Enable Web Enable Web Enable Web
Blocking. Blocking. Blocking. Blocking.
How do I allow incoming services such as UDP, POP3,
Telnet, and Web?
1 Using your Web browser, go to http://192.168.111.1.
2 Click Services and then click Allowed Incoming Services.