Yamaha DVD-C961 - Manual (Page 40)

36
En
Setup Menu
Adjusting the picture settings
This unit comes with three predefined sets of
picture color settings and one personal setting
that you can define yourself.
• Select [PICTURE SETTING] in “VIDEO
SETUP PAGE”.
STANDARD
Select this for the standard picture setting.
BRIGHT
Select this to make the TV picture brighter.
SOFT
Select this to make the TV picture softer.
PERSONAL
Select this to personalize your picture color by
adjusting the brightness, sharpness, contrast,
tint and color (saturation).
BRIGHTNESS
Increase or decrease the value to adjust the
overall brightness. Zero (0) is the average
brightness setting value.
Control range: –20 to +20
SHARPNESS
Increase or decrease the value to adjust the
sharpness of edges in the image. Zero (0) is the
average sharpness setting value.
Control range: –7 to +7
CONTRAST
Increase or decrease the value to adjust the
contrast between a light portion and dark
portion. Zero (0) is the average contrast setting
value.
Control range: –16 to +16
TINT
Increase or decrease the value to adjust the
density of color. Zero (0) is the average tint
setting value.
Control range: –9 to +9
COLOR
Increase or decrease the value to adjust the red/
green balance. Zero (0) is the average color
setting value.
Control range: –9 to +9
All picture settings are not available for HDMI
output.
Adjusting the advanced picture
settings
You can fine-tune the following video
parameters.
We recommend setting the aspect ratio on
your TV if the function is available.
• Select [ADV PICTURE] in “VIDEO
SETUP PAGE”.
DCDI
DCDi (Directional Correction Deinterlacing)
computes and tracks the angle of the screen
edge to fill in the missing pixel on the TV
screen. DCDi optimizes the image quality
significantly, especially during the slow
motion playback. This function is available for
progressive scan output only.
OFF
Select this to disable the DCDi function.
ON
Select this to enable the DCDi function.
GAMMA
Adjust the intensity of the picture non-linearly.
A positive value enables you to bring out low
level detail in dark scenes, while a negative
value emphasizes contrast. This function is not
available for HDMI output.
Control range: –7 to +7
CHROMA DELAY
The chroma (color) and luminance
(brightness) signals are not synchronized. You
can adjust the advance delay of the chroma
signal to yield a perfectly clear picture. This
function is not available for HDMI output.
Control range: –3 to +3
Note