Getting started – VTech 91-02239-001 User Manual

Page 4

TAR

WARNING:
All packing materials such as tape, plastic sheets, wire ties and tags are not part of this toy,

and should be discarded for your child’s safety.

GETTING STARTED

POWER SOURCE

The Nitro Jr. Notebook

™

operates on 3 “AA” batteries (UM-3/LR6) or a VTech

adaptor (sold separately).

BATTERY INSTALLATION

NOTE: For best performance, remove all factory-installed

batteries and use new, alkaline batteries.
1. Make sure the unit is turned OFF.
2. Locate the battery cover at the bottom of the unit, open

the battery door.

3. Install 3 new “AA” batteries (UM-3/LR6) as illustrated.
4. Close the battery cover.

IMPORTANT: Please replace the batteries in about 15 seconds or you will lose any saved

information.

BATTERY NOTICE

• Install batteries correctly observing the polarity (+, -) signs to avoid leakage.
• Do not mix old and new batteries.
• Do not mix batteries of different types: alkaline, standard (carbon-zinc) or rechargeable

(nickel-cadmium).

• Remove the batteries from the equipment when the unit will not be used for an

extended period of time

• Always remove exhausted batteries from the equipment.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
• Only batteries of the same and equivalent type as recommended are to be used.

WE DO NOT RECOMMEND THE USE OF RECHARGEABLE BATTERIES.

74400 IM.indd 4

5/19/07 9:26:21 AM