Verilux VF08 - Manual (Page 4)

4
Assembly Instructions
Before assembling, please review all instructions. Please refer to the
lamp diagram on page 5.
1. Carefully open box to avoid damaging the lamp when using a sharp
knife.
2. Remove lamp and lay on floor.
3. Screw shaft (B) into the base (A) and hand tighten.
4. Next, screw shaft section (C) into shaft (B) and hand tighten.
5. Finally, screw the lamp upper assembly (D) into assembled lamp
post (A,B,C) and tighten.
6. Using a Philips head screwdriver, carefully unscrew the three
screws holding the Optix ® Glare Control Filter in place. Remove
filter and save for later.
7. Carefully insert the GU-24 Natural Spectrum ® light bulb (included)
into lamp by firmly holding bulb base and pushing down and
rotating slightly in a clockwise direction to seat properly. Note:
Make sure bulb is fully inserted into the socket. The bottom of the
bulb base should touch the plastic housing of the lamp.
8. Place Optix filter on lip of of inner shade cup, align holes and
tighten Philips head screw. DO NOT OVERTIGHTEN. Insert the
two remaining screws and tighten.
9. Plug lamp into an appropriate outlet and turn on the switch.
10. Adjust height for optimum illumination.
11. Do not use with an extension cord or on a circuit with a dimmer
switch.
12. Save the packaging in case you need to send the lamp to Verilux ®
for servicing.