Universal Electronics Atlas CABLE 4 - Manual (Page 12)

PROGRAMMING TV/VCR COMBO CONTROL
If you own a TV/VCR Combo, perform the following
instructions to control this device:
1. Turn on your TV/VCR Combo and insert a
video cassette.
2. On the remote control, press AUX once; it will
blink once. Then press and hold SETUP until
the AUX key blinks twice, then release SETUP.
3. Use the Setup Codes For TV/VCR Combos (on
page 20) to locate the brand name and then
enter the first four-digit code for your TV/VCR
Combo. If you perform this procedure
correctly, the AUX key will blink twice.
NOTE: If the AUX key did not blink twice after
entering the code’s last digit, then repeat steps 2
through 3 and try entering the same code again.
If you’ve located a TV/VCR setup code that
works for your TV/VCR Combo and a separate
TV code is also listed, you’ll need to program
this code into the remote control to access
volume control (see Programming Device
Control on page 10).
4. Aim the remote control at your TV/VCR
Combo and press PWR once. The device
should turn off. If it does not respond, repeat
steps 2 through 3, trying each code listed for
your brand until you find one that works.
If it still does not respond, try searching for
the code (see Searching For Your Code on the
page 24).
5. For future reference, write down each working
device code in the boxes below:
TV/VCR Code
TV Code
(if used)
12
Atlas DV R/PVR Manual 3/20/03 5:00 PM Page 12